Pyle 1,400-watt 2-channel Vehicle Audio Amplifier, Black, 4.99 lb

I bought one of these amps 5 years ago for my Jeep thinking it would be a cheap amp to get me by till I could afford something better. It has preformed so well I never did replace it. Now when I got a second car I looked it up on amazon and purchased the same amp.

i bridged my 10"pyle chopper series sub to this amp and it has tbs power as they say it does i have of sub and it vibrates everything inside my car .GREAT JOB PYLE i have never used pyle till now its cost efficient too id recommend this setup to anyone with small budget and great sound

I received this Amp today. Will give an update to how it performed then I will definitely give a true rating. Update... i have finally installed this amplifier and i must say for a low budget amp it really performance well. i' ve hook up to it a 12 inch mid range woofer and 2 tweeters and menh! it really increase the sound in my vehicle. i will definately add the front door speakers to the amp in the future.

Awesome amp much better than i expected for the price. I have it powering 2 12" W2 JLs on 1 channel and it really pushes them hard. I have never had it go into protection mode like I have had with other name brand amps. Very reliable and great price. I deffinatly recomend this amp

This thing rocks, but don't try to bridge two high end 4 ohm subs to it, and expect it to handle that. Keep the amp in it's spec range and you'll be just fine.This thing ain't bad man, I'm pushing two Pyle 10" 1000 watt subwoofers, and this handles it well so far. I don't have it bridged, I have the subs wired in parallel at 2 ohms each, and the amp gets pretty warm but does not go into protection.If your just looking for something inexpensive to play with, this will do the job. I had a boss amp in the same price range, and it didn't hit as hard as thing does.Be easy with the speaker terminals, I stripped one pretty easily, but I made it work, and I am not too worried about, since it was inexpensive.