Edelbrock 1407 Performer 750 CFM Manual Carb/Air/Fuel Kit,BLK FIN

Top off your engine with these carburetor air/fuel installation kits. Complete installation kit includes mounting hardware. Kit Includes: (1) Edelbrock 1407 Performer 4 Barrel Carburetor, 750 CFM, Manual Choke. (1) 14 Inch Fully Finned Round Air Cleaner Set, Black Aluminum. (1) Edelbrock 81263 Fuel Line Kit for Performer/Thunder Series, 3/8" Barb. (1) 1-1/2" Liquid-Filled Fuel Pressure Gauge, 0-15 PSI. (1) Carburetor Stud Kit, 1-3/8 Inch. Edelbrock 1407 Performer 4 Barrel Carburetor, 750 CFM, Manual Choke Edelbrock Performer Series carbs have proven themselves to be easy to tune with great drivability. Whether you need to replace an aging stock four barrel carb or are looking for a performance carb to top off your hot rod, the Edelbrock Performer Series four barrel carbs are the best choice for performance and value. All Edelbrock products are proudly made in the U.S.A. This 750 CFM 4 barrel carburetor is designed and calibrated for optimum street performance in small-block and big-block engines with Performer RPM, RPM Air-Gap and Torker II manifolds and with Performer manifolds on large cubic-inch engines. Includes manual choke and detailed instructions. Ford/Mopar throttle adapter arms sold separately. Features: Manual choke. Bolt-on-and-run performance right out of the box. Smooth throttle response throughout the power band. Uses metering rods to transition between circuits - rods can be changed in seconds without carburetor removal or draining fuel. Float levels are factory set; adjustments are rarely needed. Change jets, adjust floats & replace needles/seats without draining fuel or removing carb. Two-piece design means no gaskets below the fuel level for leak-free operation. Lightweight all-aluminum body is compatible with gasohol and blended fuels. Includes both timed and full vacuum ports for ignition advance. 14 Inch Fully Finned Round Air Cleaner Set, Black Aluminum Fits 5-1/8" carb neck. 14" diameter. 3" tall paper filter. Black polished aluminum air cleaner. Features a full finned top. 5" mounting stud included. Carburetor base provides a 1" drop from the neck of the carburetor. Edelbrock 81263 Fuel Line Kit for Performer/Thunder Series, 3/8" Barb For Performer And Thunder Series Carburetors. Provides a clean and custom plumbing solution. Single Feed. Without Filter. 3/8" Barbed Inlet. Black steel. 1-1/2" Liquid-Filled Fuel Pressure Gauge, 0-15 PSI Appropriate fuel pressure is important for adjusting your fuel system to achieve optimal performance, which means an accurate pressure gauge is equally important. Built for superior precision. Liquid filled and available for carbureted and fuel injected applications. 0-15 PSI. 1-1/2" diameter. Carburetor Stud Kit, 1-3/8 Inch Easy installation/removal of carb plates. Includes zinc plated steel studs, nuts and washers. 1-3/8" tall.

Delivers smooth throttle response throughout the power band Two-piece design means no gaskets below the fuel level for leak-free operation Black full finned polished aluminum air cleaner top with 5" mounting stud Fuel line is designed to provide a clean and custom plumbing solution All Edelbrock products are proudly made in the U.S.A