E900 HARDWARE P928 28-Inch Plug-End Garage Door Spring (.148" #9 Wire)

The E900 HARDWARE P928 28 Inch Plug End Garage Door Spring is used as a spring replacement for 7 ft. or higher one piece garage doors. Two springs are required to operate the 7 ft. one piece door. This product is perfect for DIY garage door repair.

The E900 HARDWARE P928 28 Inch Plug End Garage Door Spring is used as a spring replacement for 7 ft. or higher one piece garage doors. Two springs are required to operate the 7 ft. one piece door. This product is perfect for DIY garage door repair. Technical Details (P928 28 Inch Plug End Garage Door Spring) Replacement spring for garage doors using the 900 Series hardware kit Safety containment to prevent it from coming loose Maximum weight limit is 75 lb. Minimum 1 in. low headroom required Length over coils = 28 in. Outside diameter = 1-1/4 in. Wire diameter gauge = (0.148", #9) Initial tension = 45-55 lbs. Maximum allowable stretch = 18.5 in. One Year Manufacturer Warranty E900 HARDWARE warrants products against defects or failures for one year from the purchase date. Should you incur a defect or failure during this period, E900 HARDWARE will replace your product at no additional charge. Need Application Help? We know that you want to be sure that you are replacing the correct garage door hardware! If you have any questions about this product's compatibility for your specific application, please reach out and ask our experts! PLEASE INSTALL ALL HARDWARE AS DIRECTED.