Ashly Audio ASH-NE4250PE 4 Channel Network Enabled Amplifier with DSP 4 x 250W at 4 Ohms

4 Channel Network Enabled Amplifier with DSP 4 x 250W at 4 Ohms Our multi-channel ne (Networked-Enabled) Series Amplifiers are uniquely designed around an energy efficient Class-D platform with a switching power supply.Connecting and controlling an amplifier for networked systems has now been simplified with ne Amplifiers. This line offers ease of use, setup and control using standard 10/100 Ethernet protocol and Protea ne Software. No special outboard control units are needed. Choose either the ne4250 (4-channel) or ne8250 (8-channel) pack s rated at 250W per channel, with separate Hi-Z and Low-Z models. ne Series Amplifiers are offered in two separate platforms-the standard network amplifier or a network amplifier with an on-board Protea DSP Processor. Each can be customized for any installation by adding your choice of AES3 inputs, mic pre inputs, CobraNet or Dante modules. Features 10/100 Ethernet comes standard for remote control and monitoring FIR Filter capable (with DSP) Low-Z, 25V, 70V, 100V models Protea DSP, AES3, CobraNetr and Danter input options Switched-mode power supply, Class-D output Stepped, calibrated input attenuators Remote power standby Disable all front panel controls via software Temperature sensitive variable speed fan with side-to-front airflow Selectable HPF frequencies 80Hz, 400Hz, off on 25V, 70V, and 100V models 4-stage level metersSpecifications Safety Compliance: cTUVus, CE, FCC, RoHS Controls: Individual input attenuators, AC Power Switch Cooling: Temp dependent speed-controlled fan (Side-in, Front-out) LED Indicators: Unit Status POWER Blue Switch: On, Off Weight: 29. 1 lbs - SKU: TCNCD332307

The Ashly nXp3.04 Programmable Output Power Amplifier features lightweight,energy efficient Class D switching amplifier technology combined with a switchmode power supply. Use rear panel DIP switches to program each channel outputfor either High-Z (70V or 100V Constant Voltage) or Low-Z (stable down to 2Ohms) operation. When in Sleep Mode, the nXp3.04 amplifier draws less than 1W.This amplifier is designed to meet the most demanding live sound and fixed installationsound systems in stadiums, arenas, performance venues, worship spaces, and conventioncenters. The Network Power Amplifier adds 32-bit SHARC DSP processing (with 48 kHz and96 kHz sampling) as standard equipment for comprehensive audio processing, withbuilt-in signal generator for test tone, and noise-masking. Plus, you get precisionload impedance monitoring on each amplifier channel output. PRODUCT HIGHLIGHTS Programmable output on each channel Power saving, Energy Management System Front panel power switch & level controls Neutrik Combo XLR: 1/4" TRS jack Euroblock input connectors Rear panel DIP switches per channel Remote DC level control on each input channel Ethernet port & Serial data port Switch mode power supply Extensive protection circuitry Multiple independent internal power supplies Uses Protea software Preset recall & detachable AC mains connector Auxiliary preamp & fault condition logic outputs