Avalon High Rise Spout Replacement for 5001 Kitchen and Bathroom Faucet

The spout reach is important because it determines where the water will fall in the sink. If a spout only reaches a couple inches from the back of the sink, it could be difficult to fill a large pot that sits in the sink. It could also be hard to run water in every bowl of a three-bowl sink. Spout reach is measured from the center of the spout base horizontally out to the water stream. Spout height is measured from the sink/countertop surface vertically up to the highest point.

8 inch Swivel Swing Nozzle Spout: 8 inch spout reach and 5.5 inch spout height, 2.2GPM Max water Flow, good design for wall mount or deck mount faucet even commercial pre-rinse faucet working on 1 or 2 prep & utility compartment sinks. 360°Short Add-on Spout: lead free stainless steel constructed, polished chrome surface with high hardness and heat resistance characteristics. You can rotated the spout 360 degree by hand, easy to control and use. Easy to Install and Remove: Max 2.2GPM, easy to install it, just remove the old one and install the new one less than 5 minutes by DIY installation Commercial Faucet Spout Replacement: This 8 inch swivel spout is designed for wall mount or deck mount commercial faucet with M25*1.25mm connector size, 8" add on spout is designed for 1 or 2 compartment, please pay attention)