Big Horn 19405 High Pressure Glue Injector

Big Horn 19405 High Pressure Glue Injector. Furniture repair without disassembly. Easily repair furniture joints, veneers and cabinetry and more. Solid brass nozzle, high impact plastic body, removable plunger and nozzle for easy cleaning. Filling Instructions: Moisten O-Ring before inserting the plunger and screwing the brass tip into the barrel. Pull the plunger back beyond the glue filling port, using a white or yellow water-based glue press nozzle against glue port and fill injector barrel. Wet barrel before use. Injector may be immersed in water to prevent glue from hardening. Cleaning & Storage: Clean with warm water and brush. Brass nozzle may be removed for thorough cleaning. Regularly lubricate, using cooking oil on O-Ring to maintain a smooth and airtight seal. Do not allow glue to dry in the injector. Do not use solvent to clean. Applications: Reglue Joints (Furniture, Doors, Stair Rails, Cabinetry and more) Drill a 1/32" hole that opens into a cavity where the joint needs reglueing (1/16" nozzle for higher volume dispensing is available from your retailer). Place the brass tip into the drilled hole, inject until excess glue begins to appear around joints. Remove excess glue with damp towel and apply clamps. When dry remove the clamps and fill the drilled hole if necessary. Touch up with color. Repair Veneer: Drill a 1/32" hole into the veneer where gluing is needed. Inject a small amount of glue into the drilled hole. Roll the area with a roller to spread the glue evenly. TIP: A wooder wallpaper roller works well. Remove excess glue and apply a clamp | Repair Squeaky Flooring: At squeak location, drill a 1/32" hole deep enough to open into the cavity between the backing and flooring. Place the brass tip into the drilled hole and dispense glue. Wipe excess glue, with damp towel. When dry, fill the drilled hole and touch up with color.

High Impact Plastic Body | High Pressure Glue Injector | Removable Plunger | Manufactured by Maxmetrix LLC | Made in USA.