eSUN 1.75mm Yellow PLA PRO (PLA+) 3D Printer Filament 1KG Spool (2.2lbs), Yellow

eSUN 3D Printer Filament: PLA PRO (PLA+) PLA+ is like PLA, but better! As compared to PLA, PLA+ (PLA PRO) is: - Several times stronger than standard PLA (printouts are very hard to break!) - Superb layer bonding - High rigidity - Better glossiness - Smoother finish - No cracking or brittle problems 1KG net (approximately 2.2 lbs) PLA Filament with Clear Spool eSUN PLA PRO 3D Printer Filament Vacuumed Sealed With Desiccant. Superb layer bonding. 1.75mm Filament Diameter (Dimensional Accuracy +/- 0.05mm) Recommended Extrusion/Nozzle Temperature 205C - 225C Spool Diameter: 8" - Spool Width: 2.50" - Spool Hub Hole Diameter: 2.05" - Inner Circle Diameter: 3.5" Extrusion Temperature Range: 205 to 225 Celsius PLA PRO (PLA+) print temperature is about 20 Celsius higher than regular PLA. Most users print at around 210 to 215 Celsius. PLA+ has a low shrage rate and sticks very well both to bed and layer to layer. PLA+ is a biological , extracted and purified from corn grain, eco- friendly, odorless, and harmless to human. This product is vacuum packed with a manual. It is not easy to absorb moisture and is ok for long-term storage. It absorbs slower and less moisture than standard PLA. WARNING: This filament - when used for 3D printing - can expose you and others in the same room to chemicals known to the State of California to cause cancer. www.p65Warnings.ca.gov ALWAYS USE THIS PRODUCT IN A WELL VENTILATED AREA.

PLA+ (like PLA, but better) Extremely strong Smooth finish