GlassParency 1072 Graphene Coating 50 ml

GlassParency Graphene Coating is a unique paint coating that combines the protection power of Ceramic AND Graphene to give you the most durable protection and a much easier application process! GlassParency Graphene Coating provide insane levels of gloss, slickness, and hydrophobicity! GlassParency Graphene Coating can be layered to last for more than 5 years at a time with proper maintenance! But even one layer can last 3-4 years! Increased heat dispersion will provide better resistance to harmful substances like water spots and bird droppings! You can even apply GlassParency Graphene Coating to carbon fiber surfaces as well as paint surfaces!

Directions: Perform any necessary washing, iron decontamination, claying, polishing, and panel prep application. Make sure the vehicle is cool to the touch. Shake GlassParency Graphene Coating well before applying. Apply several drops of GlassParency Graphene Coating onto a coating applicator. Ensure the cap is screwed back on the bottle tightly to avoid spillage or hardening of GlassParency Graphene Coating in the bottle. Start on the upper panels and work your way down to the lower panels as you go. Working in 2' x 2' sections, use a cross-hatch pattern. Move the applicator across the entire section going left to right, then do the same but moving top to bottom. This method ensures even coverage without any missing spots. Allow GlassParency Graphene Coating 2-4 minutes (varies depending on elevation and humidity) to "flash". This will look like the surface has a rainbow-like appearance. This means that GlassParency Graphene Coating has begun to evaporate and cure. After allowing GlassParency Graphene Coating as evaporated, use a clean, high-quality microfiber towel to buff the surface with light pressure. Use the same cross-hatch pattern you used to when applying GlassParency Graphene Coating. You should also flip your towel to a clean side occasionally to ensure you are wiping with clean fibers. Make sure to watch for high-spots! High spots occur when all residue has not been removed completely and evenly. High-spots will look darker than other areas of that section, so if an area looks darker, give it another wipe. If you wait too long to flatten the high-spots, the surface will looks wavy rather than having an even gloss. Continue in this manner until you have fully coating all the surfaces you want to coat. If you intend to apply multiple layers, allow GlassParency Graphene Coating to cure on the surface for 40-60 minutes before applying another layer. The surface will feel "tacky" when it is time to apply your next layer. If you allow GlassParency Graphene Coating to sure too much before applying the next layer, it will not adhere properly and will cause the coating to look "foggy" Allow GlassParency Graphene Coating to cure for at least 24 hours! During this time, do not drive your car or expose it to any environmental contaminants. It is best to keep it inside of your garage if possible. Even after the 24 curing process, you should still avoid exposure to the following elements that may decrease coating lifetime or cause imperfections: Hard mineral water Abrasives or washing Automatic brush washes High or Low pH Soaps Avoid parking under trees or other locations where bird droppings or tree sap may fall on the coating Federal regulations prohibit the shipment of this products by air, UPS 3 Day, UPS 2, or US Mail. This item is shipped by UPS Ground only. Sorry but no APO or FPO addresses.