Gymark 3 Channel Guitar Preamp Pedal Effect Pedal For KSR Ceres 3ch Preamp

Features: - 3 channels including clean, rhythm and lead (SOLO channel) - Make toggle switches downwards, it is the tone of simulated colossH100 amplifier. The gain of this amplifier is not much different from that of Artemis100 - Also suitable for rock, metal and new style - Regardless of amplifiers used, overdrive can be completed. It can be adjusted by a Gain knob - Two tones can be set according to rhythm mode and solo mode - If the gain is not enough, a booster can be connected in series in front of this device to push its gain and dynamics again. - If clean channel is selected, either clean or bypass or buffer can be used. Connect main sound source (overdrive distortion pedal, metal pedal or fuzz pedal) in series in front of this device. However, if the main audio source is connected, it is not recommended to turn on three power amplifier modes inside. Adjust the gain of this device in accordance with the gain of the main sound source connected - Clean channel is divided into two control volume levels, i.e., level and tone. Buffer channel without adjustable knob - Beautiful indicator light. When the switch in the upper left corner is adjusted to clean channel, green light is on. The light is off when it is in bypass mode. When the switch is adjusted to buffer channel, fluorescent green light will light up, press the bypass button to switch between clean/straight-through/buffer or three-mode amp. Blue light in rhythm. Blue and white lights in solo How to String into Amp or Cabinet Simulation? 1. String directly into the amp input of an amplifier or return under the loop of speaker. 2. String into the input of cabinet simulation without preamp and then into a mixer or a sound card. 3. If there is an original clone of our studio's simplifier, it can go directly to the R port of return, and then enter a sound card or enter a amp or enter a mixer or a store audio. 4. It can enter the input of our studio simplifier, preamp. Be sure to turn the gain of the simplifier to a small value, and it can't exceed 9 o'clock at most (this method is NOT recommended). 5. If you use a single-channel guitar amp, that is, a guitar amp has no distortion or clean, it is not suitable to fit the effect pedal. How to Connect Peripherals? It is this out that connects to delayed reverberation, and then to a speaker amp or the input of cabinet simulation or our simplifer. Package Included: - 1 x Preamp Pedal

3 channels including clean, rhythm and lead (SOLO channel) Make toggle switches downwards, it is the tone of simulated colossH100 amplifier The gain of this amplifier is not much different from that of Artemis100 Also suitable for rock, metal and new style Regardless of amplifiers used, overdrive can be completed. It can be adjusted by a Gain knob Two tones can be set according to rhythm mode and solo mode If the gain is not enough, a booster can be connected in series in front of this device to push its gain and dynamics again.