Pentair PD-50-934 Polypropylene Filter Cartridge

This Pentek PD-50-934 polypropylene filter cartridge reduces sand, silt, scale, and rust particles in commercial drinking water and industrial fluid applications. It has a nominal filtration rating of 50 microns at an efficiency of 85 percent. The filter is made of thermally bonded polypropylene microfibers for resistance to chemicals and bacteria and minimal fiber release. It has an initial pressure drop of less than 2 pounds per square inch (psi) at a flow rate of 2 gallons per minute (gpm), and operates over a temperature range of 40 to 175 degrees F (4.4 to 79.4 degrees C). This polypropylene filter cartridge meets National Sanitation Foundation/American National Standards Institute (NSF/ANSI) standard 42 for quality assurance, and is used for treatment of commercial drinking water and industrial filtration applications. Water filters remove undesirable particles, chemicals, and microorganisms from water by means of a semipermeable barrier, adsorption, or biological processes. They are made of densely packed synthetic or natural fibers that trap suspended particles, materials that block microbes or adsorb unwanted chemicals, or substances that cause a chemical change, such as acid neutralization. For most residential, commercial, and industrial applications, water filters are manufactured in the form of replaceable cartridges that fit inside permanent housings. Filtration systems typically consist of a series of two or more types of filters, each designed to remove different contaminants. The performance of filters is measured by the minimum particle size that is blocked, the percentage of particles or microorganisms that are removed, the downstream concentration of unwanted chemicals, the maximum flow rate, and the amount of water that can be filtered before the filter must be replaced. Water filters are used in a wide range of applications, including drinking water purification, swimming pools, industrial processes, and irrigation, among others. Pentair manufactures industrial, commercial, and residential water filtration components and systems. The company, founded in 1966 and headquartered in Minneapolis, MN, meets International Organization for Standardization (ISO) standards 9001 and 14001 for quality assurance. Materials: Plastic Set includes: One (1) Replacement Water Filter Dimensions: 3 inches inches x 3 inches inches x 10 inches Care instructions: See Product Manual Reduces sand, silt, scale, and rust particles in commercial drinking water and industrial fluid applications Nominal filtration rating of 50 microns Bonded polypropylene microfiber for resistance to chemicals and bacteria Initial pressure drop of less than 2 psi at a flow rate of 2 gpm Temperature range of 40 to 175 degrees F (4.4 to 79.4 degrees C) Material: Plastic

Materials: Plastic Set includes: One (1) Replacement Water Filter Dimensions: 3 inches inches x 3 inches inches x 10 inches