Dremel 530 3/4 inch Stainless Steel Brush for Rotary Tools

[This review was collected as part of a promotion.] Used these to clean up some lightly rusted tools I had been neglecting. I was running them at a lower speed so as to not take off too much material or mess up the finish on the tools. They took all the surface rust off and seemed to hold their condition compared to cheap knock offs that don't last 5 minutes. Trust me, I've bought the HF stuff and it's junk. These are so much better material and quality.

[This review was collected as part of a promotion.] Very durable brushes. I used them for a small project. I found thee brushes to be better than I was getting. They were durable and held up. Did not break like the cheap stuff that is coming into the markets here.

[This review was collected as part of a promotion.] I used this to clean and polish a kitchen knife set. The unsightly marks came off with ease and it appears that I'll be able to get a few more uses of the brush set. They didn't wear down much, most likely due to the surface that it was being used on. The knife surfaces were smooth. On a rough surface the wear of the brushes may have been more pronounced. I like these brushes and they will definitely be used again.

[This review was collected as part of a promotion.] I received these as well as the carbon steel brushes and saw they were recommended for removing rust, and what better test than my project truck. The carbon steel brushes worked decent, but the stainless did a far superior job! The photos speak for themselves in the speed in which these quickly cleared down to bare metal. I will say for something as large as a truck, these may not be the ideal tool for the job just due to the size. However, if you have something smaller, these will certainly do the job quickly and efficiently.

[This review was collected as part of a promotion.] I really like using the attachments that are made for the Dremel. And these steel brushes are pretty good. My only use so far for them was cleaning up some rust off of the deck grill legs just to pretty it up a little but it did well. It wasn't a lot of rust but it did remove what was there. I was thinking they wouldn't hold up on the grill but it did. I hope they last a while because I keep forgetting my tools out on the deck and they rust often....lol...but at least have the Dremel and these brushes to clean things up.