Torin Jacks 2 Ton Bottle Jack for Car Repair

I cannot believe how efficient this little jack is. I have an older Jeep that isn't lifted higher than it came from the factory but it's still a lot higher than a standard sedan. It can be difficult and time consuming using the standard screw jacks that come with any vehicle. There are usually 6 or 7 parts that are easily lost or bent and it can be frustrating. I used this to see how much easier it would be to lift the rear end of my Jeep than using the standard issue jack that came with it. Using the standard issue jack took a little over 5 minutes to go from removing it from storage to first contact with the vehicle. That can be pretty frustrating, especially if you're on the side of the interstate and you're likely in a hurry as so many of us are these days. It took less than 2 minutes to go from storage to first contact with this jack. I had my Jeep off the ground by about 2 inches in around 8 pumps of the handle. Uses standard hydraulic jack oil and has a very small insertion point so you're not going to make a huge mess pouring or using a funnel like you would a floor jack. Fits securely and discretely into your vehicle's trunk or in a garage. Takes up very little space anywhere you choose to store it. Has gripping teeth on point of contact in case you need to use wood to get a little extra space to reach higher contact points on your vehicle. With a 2-ton capacity, you can use it for any vehicle that you have that isn't a large commercial vehicle. So happy to have this little jack!