Kern UCI Hardness Maximum Tester for HV 1

UCI Hardness Maximum Tester for HV 1 Features The SAUTER HO measures by using a vibrating rod which vibrates at ultrasonic frequency This pressed onto the sample at a defined test force At the lower end there is a Vickers indenter Its resonant frequency increases as soon as an indentation is created Through appropriate adjustment of the device, the resulting change in resonant frequency is matched with the corresponding Vickers hardness The HO ultrasound hardness testing system is primarily used for measuring small forgings, castings, welding points, punched parts, casting tools The flanks of gear wheels as well as for measuring the influence of warmth or heat Advantages compared with Rockwell and Brinell: Less test force and therefore only microscopic, small penetrations means that the testing Advantages compared with Vickers: Demanding optical measuring is not required You can therefore carry out measurements directly on-site, for example, on a permanently installed workpiece Advantages compared with Leeb-The high requirements for the weight of the test object are no longer required, in most case Standards: The device fulfils these technical standards DIN 50159-1-2008: ASTMA1038-2005: JB/T9377-2013 Measurement data memory saves up to 1000 measurement groups each with 20 individual values Mini statistics function: Display of the measuring result, the number of measurements, the maximum Minimum value as well as the average value and the standard deviation The device can be set to both standard hardness test blocks and also to up to 20 reference calibration values When doing this it is possible to measure different materials quickly Without having to re-adjust the device to the individual material Scope of supplies display unit, UCI sensor unit, transport case, software to transfer the saved data to the PCSpecifications Weight: 12 lbs - SKU: TVTC1611

Kern UCI Hardness Maximum Tester for HV 1