Krylon Colormaster Spray Paint, 12oz, Gloss Finish, Bright Idea

After using Rustoleum and experiencing bad results, I decided to give Krylon a try. BEST DECISION EVER. The nozzle sprays evenly and just the right amount so I never experienced any run or drip, and I didn't have to worry if I was spraying too close. Sprayed 1 tacky coat, then 2 wet coats 10 minutes apart, and let it dry for two days. Then sanded with 600 and I never had any issues with the next layers, in fact the newer coats ended up even nicer. After I sprayed my color, although it was suggested not to, I applied Clear Gloss on top of it the same way, about 10-12 coats (3 per day), and let it dry for a week after the final spray. Then I sanded with 1000, 1500, 2000 and 2500 grit and then hand buffed and polished. I never thought I could have this finish quality without a spray booth or spray guns. Patience is the key. Also read weather and humidity conditions before you spray, it seriously can affect your project.

I have used can spray paint for 40 years and this is the worst product ever. It sprays unevenly, leaves a textured finish and dries before it reaches the surface. The sheen level used was the matte black. This paint ruined the project.

I purchased this to recolor some light switch plates. Says it works on plastic. I spend time to prep, making sure the plates were clean with no oil residue. I planned on several light sprays to keep it from running. Nope, no matter what I did it ran. The paint is like water, and doesn't stick to anything. I tried some other material to see if I was doing it wrong, but nope.... all ran.

Would be good if you were going for the popcorn ceiling effect. I now have to sand and prime my surface again to get rid of all the blobs this paint created. Waste of my money and more importantly my time. Too had it won't allow picture posting.

I am a hobbyist and make a lot of various models so I use a lot of different paints. This paint is VERY thin. Mind you it's not runny, it just sprays incredibly thin. The problem with Colormaster paints is that it easily "lifts" once it goes down. You cannot top coat it or it will "wrinkle" and you cannot apply a clear coat...ever. Wrinkle, wrinkle, wrinkle. Once you spray it you are done. This is TERRIBLE if you are doing multiple layers of paint and different colors on one project. I cannot recommend this paint, do not use it or you will regret it. It will totally ruin your project.