Krylon/Consumer Div Decorator Indoor/Outdoor Aerosol Paint

I purchased this to repaint some wood frames. What a mistake! I had paint everywhere. Globs of paint came out of the side of the can as I began spraying. Very little came out of the actual spray nozzle. I use spray paint all of the time with the exact same set up and I have never had this happen. Even with a massive drop cloth I still managed to get paint on my concrete patio and all over myself.

I have used Krylon Paint for YEARS. This can of spray paint is garbage dirty spray paint. Clean metal tray applied paint as if dust specs mixed in the paint. Next day lightly sanded the specs off. Wiped of the dust and smooth finish again. Re-painted the tray and same exact problem specs in the paint also this is being done indoors basement so no wind or dust in the air. Now I get a sheet of tin foil off a roll right out of the box and the same exact thing. YOU HAVE CONTAMINATED PAINT

I use spray paints almost daily for various projects. The ColorMaster line is by far my favorite! I've used on glass, wood, metal, and plastic; all with excellent results. - I'm disappointed if ever forced to buy another brand because I can't find the color needed in ColorMaster! My favorite feature is the control spray tip. It allows for excellent control, I can modulate paint flow, and not wear out my index finger. :) If there is anything I have learned with frequent use; it is that spray painting in general is not easy, and takes lots of practice to be done well! I think many people are under the misconception that spray painting is a simple and quick - 'pop off cap and spray where you stand' process. Just like brush or roller painting, PREP, STORAGE and TECHNIQUE are all imperative! FAR more important that ANY paint you choose to use. If your surface is not properly prepped, paint has been stored for two years in extreme hot/cold temps in a garage, spray nozzle is not cleaned after each use, and/or application strokes are not even sweeping motions, a poor result is typically user error.

Bought a can for a simple craft project. Repainting some white picture frames. Frames were brand new, clean, previously painted gloss white, not bare plastic. Sanded to a dull finish. Paint would not stick. Pulled away and orange pealed awful. Tried the paint on some parents rough plastic. It wouldn't stick. Tried on a wood broom handle . Was so thin it would have taken 4-5 coats to even start to cover. Tried on metal. Pulled away and wouldn't cover. Could not get smooth coverage on any surface. Awful awful paint. Won't be buying any more of this garbage.

I just painted a pinewood derby car for my daughter, and put on the first coat, waited close to 30 hours, and knocked off the gloss with some 1500 sand paper, and upon recoat, the whole car turned into a crinkly mess. Now I have less than a week to completely strip the car and start over before the race.