Rockville, ATV Waterproof 4-Channel Bluetooth Amplifier

All About Your ATV420: How To Set Up Your ATV420: How To Set Up Your ATV420 To A Head Unit: Wires, Inputs, Outputs Explained On Your ATV420: Description: The Rockville ATV420 is a 4 channel amplifier for your ATV, UTV, or motorcycle. It will deliver 125 x 4 @ 2 ohms RMS. We dyno-test the amp to make sure you get the power we promise. This amp is IP65 which means even if you submerged it in water for a few seconds it will still function fine. This means you do not need to worry about your amp breaking when you spray down your vehicle. The built-in Bluetooth is great because you do not even need a head unit or controller. You can just install this amp and wire it to your speakers and then Bluetooth your phone to the amp. This amp is super compact making it easy to install into tight spaces. If you want the most waterproof and high performing Powersport amplifier on the market then the ATV420 is a great option for you. Features: Rockville ATV420 4 Channel ATV/UTV/Motorcycle Bluetooth Amplifier IP65 Waterproof rating Micro Amp Dyno Certified RMS Power Ratings: (Certified Dyno Test / Less than 1 % THD) (Use these ratings when comparing with top brands such as Kicker, Rockford Fosgate, etc) 2 Ohms: 500 Watts (4 x 125 Watts) 4 Ohms: 360 Watts (4 x 90 Watts) Peak: (Use these ratings when comparing with the top budget brands such as Boss, Power Acoustik, etc) Peak 2 Ohms: 2,000 Watts (500 x 4 Watts) Bridged Power Rating: 4 Ohms Bridged: 500 Watts (2 x 250 Watts) Built-in Bluetooth Wireless with Auto Pairing (You can run this amp without any receiver)

Rockville, ATV Waterproof 4-Channel Bluetooth Amplifier 4 Channel ATV/UTV/Motorcycle Bluetooth Amplifier with IP65 waterproof rating Micro size amplifier designed to fit in tight spaces Dyno Certified RMS Power Ratings: 2 Ohms: 500 Watts (4 x 125 Watts), 4 Ohms: 360 Watts (4 x 90 Watts) Peak Power: 2 Ohms: 2,000 Watts (500 x 4 Watts); Bridged Power Rating: 4 Ohms Bridged: 500 Watts (2 x 250 Watts) Built-in Bluetooth Wireless with Auto Pairing, allowing operation without a receiver All inputs and wiring are sealed and covered for enhanced durability Conformal coated circuit board and anti-rust materials for longevity Digital Class D Audio Topology with distortion (THD) ≤0.5% Independent crossover controls for CH1-2 and CH3-4; configurable for full range, low pass, or high pass High Level Input (Speaker level Input) with selectable LPF/HPF crossover: 32Hz-320Hz Frequency response: 20Hz-22KHz; signal to noise ratio: ≥80dB Dimensions: 8.66" L x 3.74" W x 1.73" H; fuse rating: 40A