Kendall 54" Wall Cabinet, White

Great quality shelf. I really like the soft close doors. Perfect for over your washer and dryer

Cost should be much lower for the poor quality. Doors don't align straight. Doors aren't even the same thickness which emphasizes the poor alignment. I almost threw away the ridiculous back panel because it's a piece of cardboard. Since back is not a piece of pressboard you rely only on the beveled edge for whole inferior cabinet to sit on. You have no sturdiness or confidence in putting much of anything in the cabinet. It's actually embarrassing to have freshly painted walls and new floor and then to add this piece to the equation. I will probably replace shortly. It looks like it was engineered by elementary school children.

Too often the "put together" cabinets are missing screws, doors, etc. This one came with no missing parts. The cabinet is extremely heavy to the point that one wonders if it could stay on the wall. To that end, you must be sure to hit the studs with all the screws. I even reinforced it with additional screws and brackets just to make sure it stays put. The "back" of the cabinet is really only a piece of folded cardboard but once on the wall is only slightly noticeable through an open door. Assembly is fairly simply if one follows the enclosed directions. The hinges are nice and close the cabinets securely and quietly. I wish they had drilled more holes to adjust the shelves because a gallon bottle of bleach would only fit if the shelf was totally removed. I solved this myself by drilling additional holes.

All the parts were labeled so it was easy to follow the directions. Looks more expensive than it cost. Great value. Would definitely recommend to my friends who need extra space

Final installation of end panel proved extremely difficult. Getting the rear panel into the grooves of the end panel at the same time as engaging the pins into the cam locks couldn't be achieved with two people. Ended up cutting a small piece off the end of the back panel to avoid the problem. By the way don't try leaving the back panel out that results in mislocating final assembly screws.