LNCDIS 3D Plaster Handprint Footprint Baby Mould Hand&Foot Casting Prints Kit Cast Gift

3D Plaster Handprint Footprint Baby Mould Hand&Foot Casting Prints Kit Cast Gift Feature 100% brand new and high quality.Name :3D Baby Hand Foot plaster Keepsake Material:100% Biodegradable powder Color:WhiteNet Of Model Powder: 100gNet Of Clone Powder: 100gSafety: Non-Toxic, Non-Allergenic, 100% Biodegradable. Application: Reproduce the hand or foot of your (god-) child three dimensionally and with accurate details. Advantage: Preserve every precious detail, capture tiny toenails, fingernails, dimples & footprints ,even if baby wiggles.Dosage:0-1 years: One hand (50g) one foot (100g)1-2 years:One hand (100g) one foot (150g)2-3 years:One hand (100g) one foot (200g)3-5 years:One hand (200g) one foot (250g)Adult:One hand (300g)Couple hands:One hand (600g)Ready to work:a one-time cup: thicker, bigger, transparent the best (if the baby does not put in, you can consider the cup of tea)30-35 degrees pure water or tap water (please do not use mineral water) chopsticks，Spoon Thermometer Stopwatch: mobile phones, computers are, you can watch the clock Steps:(usually within one year of the baby a hand 50 grams, one foot 100 grams)Take clone powder 50 grams, add 1.2-1.5 times the volume of water mixed, rapid mixing, then cloning powder and water mixture into a purple paste liquid, stir it, about 1 minute or so purple gradually receded, immediately Baby's little hands or feet into the liquid, the baby's little hands or feet must be soaked in the liquid inside, do not stick to the walls of the cup, while ensuring that the baby's hand or feet do not move, about 2 and a half times the liquid will solidify, please Keep 4 minutes and then remove the baby's hand or feet, can be removed before and after the move, let the air go, slowly removed.Take the model powder 50 grams, add 1 / 3-1 / 2 of water, water do not put too much, as long as the powder and water mixture into a liquid, the more concentrated the better, even after mixing, slowly poured into the colloid , Down a little, Akira look, to avoid the gas plug in the inside.2-5 hours after the knife or hand can be used to slowly open the colloid, must be carefully poke, not anxious.(Note: the surface of the work of a little powder can be rinsed with water, placed in a ventilated place to dry, it is recommended to dry for more than 24 hours.)Color: like to paint what color to give their own works painted what color it Package Content: 1PCNet Of Model Powder1PCNet Of Clone Powder1PC Paint1PC Brush

Home decoration3D Plaster Handprint Footprint Baby Mould Hand&Foot Casting Prints Kit Cast GiftSlicer Cutting