Access Limited 2009-Current Dodge Ram 5ft 7in Bed Roll-Up Cover

Just Purchased a new 2014 Toyota Tacoma and wanted a cover that looked really good and had great quality appearance. Boy did I pick the right one! Installing the cover was quite simple . Instructions were easy to follow. I could've spent more money on another one, but the quality of this cover is great. If you want a sharp cover this is the one to buy.

Bought this cover to replace one I could no longer get parts for, wanted something from a company that will be around a while. As I grew up in the general area where this cover is made, I knew a bit about the company so the choice wasn't hard. Installation was straight forward. I held back on one star as I felt the anchors supplied to hold the side rails were on the wimpy/cheap order - bolts were 5/16" and it was a bit difficult to place them while lining up the side rails. In the end I used the anchors from my previous cover which used 3/8" bolts and the design is more robust and simpler to install. Outside of that - it is very well made and seals up everything tightly.

The tonneau cover looks great on my Tacoma. The installation was simple it took me 1 hour 30 min. The only problem that I had was one of the holes right side passenger side didn't aligned with the hole that my Tacoma had so I have to drilled another hole. But everything else was good and simple.

I bought this as a replacement to the same manufacturer's cover that I had installed 10 years ago. The original was beginning to show wear on the velcro used to hold the edges down on the side rails. There were portions that were not sticking at all anymore. The "hook" side of the velcro, the part on the cover itself, was impossible to replace. The "loop" side, on the side rails, appeared to be replaceable, but with difficulty. However, it didn't really matter due to a significant dust storm encountered on I 10 in Arizona that blew the cover completely off the bed, tearing the fabric nearly in half. That necessitated a new cover. The new cover was not too difficult to install, but I find that the clamps that hold the side rails in place tend to migrate down, eventually preventing the tailgate from closing. Then, the clamps need to be loosened and the side rails repositioned. I've got those clamps tightened as much as I dare, yet they still tend to slip over time. However, I cannot find anything else that is as easy to use, looks as good. and rolls up into such a small space when unlimited bed height is needed. I like it.

Access customer service rep sucked. Rails did not sit well with my truck box and clamps are weak and cheap. Cover it self fits well, seals well, and works pretty good. Rail and clamps striped and bent easily. I would recommend using a clamp or vise-grip on the clamp it self to hold it in place so it can be tighten with out sliding out of place. Also had better luck with the clamp lips reversed. If 1st time install I would get some help. D rings and slant back feature are not worth the extra! Get the Access original unless you want a low profile then get the low profile one..